Parts needed to hook up water to fridge How to Hook Up a Water Line to a Refrigerator From the Sink

Parts needed to hook up water to fridge

Ptsd symptoms and dating

Thread the water line, included in the ice maker installation kit, from the area behind the refrigerator to beneath the sink. If there are no branch shutoff valves, you can turn off the water by closing the main water supply valve to the entire house. Adapt-a-Tees can be used in many situations where you need an extra line.

Turn the cold water on the supply line clockwise to close it. If you don't have a convenient water supply pipe and valve near the refrigerator, you must instead find another spot to hook up the water line. Continue to 3 of 7 below. Be prepared for a small amount of Step 8 — Now your plastic water tube should be connected to the cold water valve you just installed.

Wrap threads on the cold water valve with two or three wraps of thread-seal tape. If you know of an easier way to install a water line for a refrigerator ice maker and water dispenser, please leave a comment below. Get the screws on the clamps tight enough until the sealing washer or gasket swells up. Step 6 — Pierce the Water-Supply Line With the water line to the refrigerator connected to the piercing valve, turn the knob on the valve to pierce the copper tube.

That is probably what is causing the melting and dripping! Twist the male end of a quick-tee adapter onto the valve. Use pliers to untwist the faucet supply line from the cold water supply valve.

Best shanghai dating sites

Pull the refrigerator out from the wall, so that you have enough room to work. You will need to locate where the cold water pipe is, drill to access it, and install a water valve and flexible water tubing.

This water line is connected to the rear of the refrigerator from a cold-water supply line. Connect a Refrigerator to an Icemaker HammerZone. See the installation instructions for more information. If the refrigerator has a water dispenser, flush out several A flex line or poly tubing would run from the new shut off valve to the back of the refrigerator.

Black bear white plains speed dating

Attach the Adapt-a-Tee adapter to the shutoff valve, tightening by hand at first. Like what you see? Good luck with your move!

Non religious dating websites

Keep in mind that if you are going to be installing the water line onto the kitchen water supply, make sure the line sits before the shut-off valve, so that you will not shut the water off to the fridge when working on the sink. It will be located under the sink! If you have a water dispenser on your fridge, dispense about a gallon of water and spill it down the kitchen sink drain. If your fridge has a door water dispenser, now is the perfect time to clean it.

This is such an easy process and so I created a part needed to hook up water to fridge on how to install a refrigerator water line.

Social dating network sites

Next, wrap the threads on the water-line connector that is on the back of the fridge with thread-seal tape to lubricate the threads.

Wrap the female thread on the opposite end of the adapter with thread-seal tape. Make sure NOT to drill too far and make another hole out the other side of the pipe.